Multi Metallographic Mount Holder, 1" and 25mm PELCO® Pro Slim The relatively sturdy PELCO® Silicon

The relatively sturdy PELCO® Silicon Nitride Support Film allows direct deposition of materials and/or manipulation of specimens

Center mark for quadrant location or older style

It replaces the previous #607-STM Grating Replica with 463nm pitch

chip mounting fixture

Multi Metallographic Mount Holder, 1" and 25mm PELCO® Pro Slim The relatively sturdy PELCO® SiliconDESCRIPTION Multi Metallographic Mount Holder, 1" and 25mmSpecimen holder for 4 x 1" and 25mm metallographic mounts. Holder height is 0. 41" (10. 4mm), with recessed areas 0. 31" (7. 9mm) deep. Open sides for easier sample removal. Material: machined aluminum with stainless steel allen screws. Allen wrench included. Shown holding one metallographic mount (not included). Screws used are M3 x 6mm Soc Cap, SS and M3 x 12mm Soc Cap, SS